Woodstock SHOP FOX W1828 Spécifications télécharger pdf (Page 11)

Model W1828 (For Machines Mfg. Since 4/11)

-9-

ELECTRICAL

Availability

Before installing the machine, consider the availability

and proximity of the required power supply circuit. If an

existing circuit does not meet the requirements for this

machine, a new circuit must be installed. To minimize

the risk of electrocution, fire, or equipment damage,

installation work and electrical wiring must be done by

a qualified electrician in accordance with all applicable

codes and standards.

Full-Load Current Rating

The full-load current rating is the amperage a machine

draws at 100% of the rated output power. On machines

with multiple motors, this is the amperage drawn by the

largest motor or sum of all motors and electrical devices

that might operate at one time during normal operations.

Full-Load Current Rating at 110V ............... 7.5 Amps

The full-load current is not the maximum amount of amps

that the machine will draw. If the machine is overloaded,

it will draw additional amps beyond the full-load rating.

If the machine is overloaded for a sufficient length of

time, damage, overheating, or fire may result—especially

if connected to an undersized circuit. To reduce the

risk of these hazards, avoid overloading the machine

during operation and make sure it is connected to a

power supply circuit that meets the requirements in the

following section.

Circuit Requirements

This machine is prewired to operate on a 110V power

supply circuit that has a verified ground and meets the

following requirements:

Nominal Voltage ................................... 110V/120V

Cycle ........................................................60 Hz

Phase .............................................. Single-Phase

Minimum Circuit Size ............................... 15 Amps

A power supply circuit includes all electrical equipment

between the breaker box or fuse panel in the building

and the machine. The power supply circuit used for

this machine must be sized to safely handle the full-

load current drawn from the machine for an extended

period of time. (If this machine is connected to a circuit

protected by fuses, use a time delay fuse marked D.)

Electrocution, fire, or equipment

damage may occur if machine is not

correctly grounded and connected to

the power supply.

For your own safety and protection of

property, consult a qualified electrician

if you are unsure about wiring practices

or electrical codes in your area.

Note: The circuit requirements listed in this

manual apply to a dedicated circuit—where

only one machine will be running at a

time. If this machine will be connected to

a shared circuit where multiple machines

will be running at the same time, consult

a qualified electrician to ensure that the

circuit is properly sized for safe operation.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Woodstock SHOP FOX W1828 Spécifications Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Broyeurs pour jardin Woodstock SHOP FOX W1828