Woodstock W1694 Manuel d'instructions télécharger pdf (Page 25)

OPERATIONS

-23-

• Never allow hands or push blocks to come

within 4" of the cutterhead while it is mov-

ing.

• Carefully inspect boards before jointing.

Defects such as twisting, knots, or cracks

could cause the workpiece to break apart.

• Only use clean boards. Remove all dirt,

nails, staples, imbedded gravel, etc. from

boards before jointing. Dirt and debris can

damage the cutting edge of the cutterhead

blades, resulting in unsatisfactory results.

• DO NOT joint man-made products such as

MDF, OSB, or plywood. Also, never use lam-

inates, formica or other synthetic materi-

als.

• Always joint “with” the grain. Cutting

“with” the grain is best described as feeding

boards on the jointer so the grain points

down and toward you as viewed on the edge

of the workpiece (Figure 31).

• Avoid using wood with a high moisture con-

tent. Boards with more than 20% moisture

will cause unnecessary wear on the cutter-

head blades and motor.

• Never take cuts deeper than

⁄8". Making

several shallow cuts will produce a better

finished result than one deep cut.

• Keep work area clean and free of clutter.

Figure 31.

Correct and incorrect grain

alignment to cutterhead.

Operation

Requirements

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 43 44

Pas de commentaire

Woodstock W1694 Manuel d'instructions Page 25