Woodstock M1020 Manuel d'utilisateur télécharger pdf (Page 7)

-7-

M1024 Taper Attachment

Figure 10. Deadman components.

Figure 11. Installing support rod onto

taper attachment.

Figure 12. Deadman installed onto taper

attachment.

Deadman Installation

The deadman is composed of a solid cast clamping brack-

et and a loose clamping jaw. The bracket has two holes

for clamping screws that attach the clamping jaw (Figure

10).

To attach the deadman, do these steps:

1. Place the clamping bracket over the lathe bed way

and slide the clamping jaw underneath the bracket.

2. Place clamping screws into the two holes on the

clamping bracket and tighten them.

3. Adjust the clamping screws until the clamping jaw

and bottom of the bed way are parallel. If these sur-

faces are not parallel, loosen the clamping screws

and adjust them as needed.

4. Fasten the short threaded end of the support rod

into the hole on the left side of the taper attach-

ment body and turn the rod counterclockwise until it

fits tightly (

Figure 11).

5. Place a washer over the longer threaded end of the

support rod.

6. Loosen the clamping screws enough to slide the sup-

port rod through the hole in the clamping bracket.

7. Slide a second washer over the threads, and fasten a

M10-1.5 nut to the end of the rod.

8. Adjust the position of the clamping bracket until

the support rod is parallel with the lathe bed and

tighten the clamping screws on the clamping bracket

(Figure 12).

Note: Position the deadman as close to the main

body as possible for the best stability

9. Re-attach the splash guard to the lathe and reposi-

tion the lathe as needed.

Clamping

Bracket

Bed

Way

Clamping Jaw

Support Rod

Deadman

Clamping

Screw

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Woodstock M1020 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Tours Woodstock M1020