Woodstock M1020 Manuel d'utilisateur télécharger pdf (Page 8)

-8-

M1024 Taper Attachment

OPERATIONS

Angle Adjustments

The taper angle is adjusted by loosening the two cap

screws at the ends of the taper bar on the taper attach

ment. The angle adjusting knob allows for fine control

of the angle (Figure 13). A scale on the left side of the

taper (labeled in degrees) allows you to get close to the

desired taper, but finer adjustments should be made

with an indicator and test bar. Once the desired setting

is reached, tighten the two cap screws. Double check the

setting to ensure accuracy.

Always wear safety glasses when oper-

ating the lathe. Failure to comply may

result in serious personal injury.

DO NOT investigate problems or adjust

the lathe while it is running. Wait until

the machine is turned off, unplugged

and all working parts have come to a

complete stop before proceeding!

Figure 13. Angle adjustment scale.

Scale

Angle

Adjusting

Knob

Cap Screw

on Taper

Bar

To use the taper attachment, tighten the clamping screws

on the deadman to secure it to the lathe bed. When

not in use, loosen the clamping screws. Removal of the

deadman or the taper attachment is not necessary when

changing from taper turning to straight turning.

Deadman Adjustments

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Woodstock M1020 Manuel d'utilisateur Page 8