Woodstock SHOP FOX D3274 Manuel d'instructions télécharger pdf (Page 13)

Model D3274 Gravity Feed Spray Gun w/Regulator

-11-

EXPLOSION HAZARD! Chlorinated

Solvents like Tricloroethane and

Methylene Chloride (methyl chloride)

can chemically react with aluminum

and may explode. Many parts in spray

guns are made of aluminum. Read

solvent label carefully before using

solvent.

NOTICE

DO NOT soak the spray gun body

in solvent. Prolonged exposure to

solvent will rapidly deteriorate the

spray gun washers and seals. Ignoring

this notice will void your warranty.

Lubrication

Lubricate the following areas with

spray gun lube after cleaning:

A. Atomizing Cap Threads

B. Air Valve Packing

C. Trigger Pin

D. Air Flow Control Valve

E. Pattern Control

F. Fluid Control Knob

After each cleaning, apply a thin film

of petroleum jelly to the needle spring

before reassembling.

Figure 13. Lubrication points.

A

B

C

D

E

F

Depending on the amount of use and the

type of material used, the spray gun may

need to be disassembled and cleaned

beyond what is mentioned on Page 10.

If spray patterns become affected due

to internal blockages or the gun will be

stored for an extended amount of time,

follow these additional cleaning instruc-

tions.

Advanced spray gun cleaning:

1. Follow Steps 1–5 on Page 10.

2. Insert the bigger end of the hex

socket tool into the head of the

disassembled spray gun. Use the

service wrench on the end of the hex

socket tool as a lever to remove the

fluid nozzle plug and seals, as shown

in Figure 10.

3. Insert the smaller end of the hex

socket tool into the head of the spray

gun. Use the service wrench on the

end of the hex socket tool as a lever

to remove the screw and spring.

4. Follow Steps 6–8 on Page 10.

Figure 12. Removing fluid nozzle plug.

Hex

Socket

Tool

Service

Wrench

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire