Woodstock SHOP FOX D3274 Manuel d'instructions télécharger pdf (Page 8)

Model D3274 Gravity Feed Spray Gun w/Regulator

-6-

• Fluid Control: Controls the volume of

material that travels through the fluid

tip by adjusting how far the trigger

can be pulled back.

• Pattern Control: Adjusts the spray

pattern from a round pattern to a

wide fan.

• Air Flow Control: Adjusts the fluid

pressure inside the spray gun.

• Atomizing Cap : Adjusts the spray

pattern from vertical to horizontal.

• T r i g g e r : Two stage trigger. Stage

one only releases compressed air for

blowing off the work piece. Stage two

sprays material.

• Material Cup: Holds the paint to be

sprayed.

• Regulator/Gauge: Regulates inlet air

pressure to the spray gun. It can be

attached directly to the gun for on-

the-spot air adjustments or to the air

source.

Note: DO NOT attach the spray gun or

regulator control to an unregulated

air source that exceeds 120 PSI.

Figure 3. Controls.

Controls

Fluid Control

Pattern Control

Atomizing

Cap

Trigger

Air Flow Control

Regulator Control

Assembly

2. Screw the cup onto the top of the

body.

3. Attach the regulator to the bottom of

the spray gun.

4. Attach the air hose to the spray gun

regulator with a

1

⁄4" NPT quick con-

nect fitting (not included).

5. Attach the spray gun to an air supply

regulated between 30 and 50 PSI.

Note: For the best results, use a hose

that will be dedicated for spray use

only. Do not use a hose that has been

used with an in-line oiler or other

possible contaminant.

Figure 2. Installing filter.

1. Insert the filter into the gun body

with the knob pointing outward (see

Figure 2).

Material Cup

Specifications

Operating Air Pressure ............ 30–50 PSI

Maximum Air Pressure ................. 70 PSI

Material Cup Capacity ................ 600 CC

Air Consumption ................. 4.2–7.1CFM

Maximum Fluid Pressure .............. 10 PSI

Cup Material ............................Plastic

Body Material ................Aluminum Alloy

Maximum Pattern Width .............250mm

Water-Based Material Compatible ......Yes

Weight ................................. 1.5 lbs.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Commentaires sur ces manuels

Pas de commentaire