Woodstock SHOP FOX W1754 Manuel d'utilisateur télécharger pdf (Page 16)

-14-

W1754 20" Planer With Mobile Base

SET UP

Before starting your machine for the first time, make

sure the gearbox has oil. The proper oil level is just even

with the bottom of the fill plug hole. The gearbox uses

80W-90W automotive grade gear oil.

To check

the gearbox oil level, do these steps:

1. Wipe the outside of the fill plug clean.

2. Using a 6mm hex wrench, remove the gearbox fill

plug

(Figure 10).

3. Using the short end of the hex wrench (make sure it

CLEAN), dip it inside the fill hole and remove it.

(Do not drop the wrench into the gearbox!)

— If the end of the hex wrench is coated with oil,

then the gearbox oil level is okay. Replace the fill

plug and continue with set up.

— If the end of the hex wrench is not coated with

oil, then fill the gearbox with 80-90W gear oil

until the oil reaches the top of the fill plug.

Note: Replace

the gearbox oil after the first 20

hours of operation. This is a normal break-in pro-

cedure. See Lubrication on Page 25.

Gearbox Oil Level

Figure 10. Gearbox fill plug location.

Connecting to Power

Make sure you have read and followed precautions listed

on Page 8,

before connecting your planer to power. The

POWER button and STOP button (Figure 11) s

hould illumi-

nate when the planer is connected to the power. Refer to

Page 40 to t

roubleshoot any problems.

4. Mount the foot pedal onto the caster and insert the

between the two parts.

5. Lock the caster and pedal in place with the E-clip and

washers,

as shown in Figure 9.

�

Figure 9. Foot pedal and caster

assembled.

Foot Pedal

Caster

Bracket

Hex Bolt

Figure 11. W1754 control panel.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Woodstock SHOP FOX W1754 Manuel d'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Woodstock SHOP FOX W1754