Woodstock SHOP FOX W1754 Manuel d'utilisateur télécharger pdf (Page 26)

-24-

W1754 20" Planer With Mobile Base

MAINTENANCE

Figure 15. Fasteners needed to be

loosened for V-belt replacement.

OFF

V-Belts

V-belt removal and replacement is simply a matter of

adjusting the motor mount, rolling the belts off of the

pulleys and replacing them with new belts, then reten-

ioning them.

Always replace V-belts with a matched set of 3 belts, or

belt tension may be unven among the 3 belts and may

cause premature belt failure.

To adjust/replace the V-belts, do these steps:

1. DISCONNECT THE PLANER FROM POWER!

2. Remove the motor and front access panels and V-

belt

cover.

3. Using a 19mm wrench, loosen the hex nuts on the

tension

rods shown in Figure 15.

4. Lift the motor up and slide the V-belts off of the

pulleys.

5. Make sure the pulleys are in alignment as outlined in

Pulley

Alignment on Page 37.

6. Slide the new belts onto the pulley, lower the

motor,

and tighten the fasteners loosened in Step 3.

7. Check belt deflection as shown in Figure .

Note: The

correct tension for the V-belts is

⁄4"–

⁄2"

deflection when pushed in the center with moderate

pressure. After the first 16 hours of belt life, reten-

sion

them, as they will stretch and seat during this

time.

8. Close the V-belt cover and replace the front and

motor

access panels.

Tension

Rod







Figure 16. Checking belt deflection.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Woodstock SHOP FOX W1754 Manuel d'utilisateur Page 26

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Woodstock SHOP FOX W1754