Woodstock M1049 Manuel d'utilisateur télécharger pdf (Page 28)

-26-

D('+09\eZ_kfgCXk_\D]^%J`eZ\/&'0

FG<I8K@FEJ

Using Centers

The MT#2 dead center is used in the tailstock, and the

MT#3 in the lathe spindle. When used in the tailstock,

make sure to keep the dead center tip and workpiece

lubricated to prevent tip galling.

To install a dead or live center into the tailstock, do

these steps:

1. Feed the quill out about 1" and insert the dead

center (Figure 23). The mating tapers provide the

locking action.

2. Move the tailstock into position and lock the

tailstock in place.

3. Feed the quill into the workpiece.

Note: DXb\jli\k_\i\`jXZ\ek\i[i`cc\[_fc\`ek_\

\e[f]k_\nfi/jointfilesconvert/532239/bg`\Z\]fik_\[\X[Z\ek\i%

4. Lock the quill into place once the live center and

the part rotate together.

Note: K_\hl`ccdXpe\\[kfY\X[aljk\[[li`e^

fg\iXk`fe%

5. To remove the dead center, retract the quill until

the dead center pops free.

To install a MT#5 dead center into the spindle, do these

steps:

1. Remove the chuck from the spindle.

2. Make sure all mating surfaces are clean and are wiped

with a thin coat of oil.

3. Install the dead center in the spindle.

4. Attach the faceplate to the spindle.

Note: N_\elj`e^k_\[\X[Z\ek\i`ek_\jg`e[c\#

lj\XcXk_\[f^jfk_XkpfligXikn`ccifkXk\n`k_

k_\jg`e[c\Xe[efkjg`efek_\[\X[Z\ek\ik`g%

=`^li\24% Faceplate and dead center

installed.

=`^li\23% Live center installed.

=X`cli\kfb\\g[\X[Z\ek\igf`ekn\cc

clYi`ZXk\[n`cc^Xcck_\[\X[Z\ek\iXe[

nfi/jointfilesconvert/532239/bg`\Z\%

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 63 64

Pas de commentaire

Woodstock M1049 Manuel d'utilisateur Page 28