Woodstock M1049 Manuel d'utilisateur télécharger pdf (Page 30)

-28-

D('+09\eZ_kfgCXk_\D]^%J`eZ\/&'0

FG<I8K@FEJ

Setting Compound Slide

The compound slide is used to cut tapers on parts or to

set the proper infeed angle when threading. It may also

be used to cut specific lengths longitudinally, when set

parallel to the spindle axis.

To set the angular position, do these steps:

1. Loosen the hex nuts, one on each side of the

compound slide (see Figure 27).

2. Rotate the compound slide to the desired angular

position using the scale.

3. Tighten the two hex nuts. Be sure to not

overtighten, as you may strip threads or crack or

distort the base casting.

Using the Tool Posts

The four-way tool post (Figure 28) is mounted on top of

the compound slide, and allows a maximum of four tools

to be loaded simultaneously.

The four-way tool post allows for quick indexing to new

tools. This is accomplished by rotating the top handle

counterclockwise and then rotating the tool post to the

desired position. Rotate the top handle clockwise to lock

the tool into position.

The universal single tool post holder can hold tool arbors

and odd shaped cutting tools (Figure 29).

=`^li\28% Four-way tool post.

=`^li\29% Universal tool post.

=`^li\27% Compound slide, scale, and

handwheel.

Scale

Hex Nut

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 63 64

Pas de commentaire

Woodstock M1049 Manuel d'utilisateur Page 30