Woodstock M1049 Manuel d'utilisateur télécharger pdf (Page 39)

-37-

D('+09\eZ_kfgCXk_\D]^%J`eZ\/&'0

J<IM@:<

Replacing the V-Belt

To replace the V-belt, do these steps:

1. DISCONNECT POWER TO THE LATHE!

2. Open the change gear access door.

3. Move the belt tension lever shown Figure 46 to

release belt tension.

4. While carefully turning the spindle pulley (Figure

47), roll off and then roll on the new belt.

5. Re-tension the belt, and close the access door.

Replacing the Cogged-

Belt

To replace the cogged-belt, do these steps:

1. DISCONNECT POWER TO THE LATHE!

2. Open the change gear access door.

3. Move the belt tension lever shown in Figure 46 to

release belt tension.

4. While carefully turning the spindle pulley (Figure

47), roll off the V-belt.

5. Using a 16mm open open-end wrench, loosen the

idler pulley spindle jam nut (Figure 47), and the

retaining nut. The idler pulley and spindle will then

slide toward the motor de-tensioning the cogged-

belt.

6. Replace the cogged-belt, and make sure to engage

the belt cogs with the lugs in the pulleys.

7. While holding the belt in tension, use the 16mm

wrench to tighten the idler pulley and spindle in

place.

8. Roll the V-belt back onto the relevant pulleys.

9. Re-tension the belt, and close the access door.

Figure 46. Belt tension lever.

Figure 47. Change gear access door open.

Idler Pulley

V-Belt

Spindle

Pulley

Cogged-Belt

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 63 64

Pas de commentaire

Woodstock M1049 Manuel d'utilisateur Page 39